FCC Statement for Users
This device complies with Part 15 of the FCC Rules when operating with the embedded antenna. Operation is subject to the following two conditions:
| 1. | This device may not cause harmful interference, and |
| 2. | This device must accept any interference received, including interference that may cause undesirable operation. |
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and may cause harmful interference to radio communications if not installed and used in accordance with the instructions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
| ￭ | Reorient or relocate the receiving antenna. |
| ￭ | Increase the separation between the equipment and the receiver. |
| ￭ | Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. |
| ￭ | Consult the dealer or an experienced technician for help. |
Any changes or modifications not expressly approved by HP Tuners could void the user’s authority to operate the equipment.
FCC RF Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter meets the Mobile requirements at a distance of 20 cm and above from the human body, in accordance to the limit(s) exposed in the RF Exposure Analysis. This transmitter also meets the Portable requirements. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with FCC multi-transmitter product procedures.
CAN ICES/NMB
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
| 1. | This device may not cause interference. |
| 2. | This device must accept any interference, including interference that may cause undesired operation of the device. |
Product Environmental Disclosure
The part(s)/product(s) in this declaration do not contain any of the substances above the maximum concentration values identified in the RoHS. This statement is based on information provided by our suppliers and our own internal knowledge of the materials used in our products. We are committed to ongoing efforts to ensure continued compliance with RoHS regulations. This statement is provided in good faith and without warranty of any kind.
To ensure compliance with WEEE and RoHS, HP Tuners engages in a take-back program in which customers may send products to the address below for proper disposal and recycling:
ATTN: Electronic Waste Disposal
700 Eastwood Lane, Buffalo Grove, IL 60089 United State of America
